Troy-bilt TB90BC Manual do Utilizador descarregar pdf (Página 11)

ASSEMBLY INSTRUCTIONS

3. While holding the locking rod, loosen the nut on

the blade by turning it clockwise with a 5/8 inch

closed-end or socket wrench (Fig. 14).

4. Remove the nut, blade retainer, and blade. Store the

nut and blade together for future use in a secure

place. Store out of reach of children.

Install the Cutting Attachment

5. Align the shaft bushing hole with the locking rod slot

and insert the locking rod into the shaft bushing hole.

(Fig. 8, Pg. 9). Place the blade retainer on the output

shaft with the flat surface against the output shaft

bushing as shown in Fig. 15. Screw the cutting

attachment counterclockwise onto the output shaft.

Tighten securely.

NOTE: The blade retainer must be installed on the

output shaft in the position shown for the cutting

attachment to work correctly.

6. Remove the locking rod.

7. Install the cutting attachment shield. See Removing

and Installing Cutting Attachment Shield, Pg. 9.

Cutting Attachment

Locking Rod

Blade Retainer

Output Shaft

Bushing

Fig. 15

WARNING: To avoid serious personal injury,

the cutting attachment shield SHALL be in

place at all times while operating the unit as

a grass trimmer.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 83 84

Sem comentários

Troy-bilt TB90BC Manual do Utilizador Página 11